Pasted Graphic 7

All About Bolting: TMT’s
Boltron Flange Bolting Robot

Mark

Mark Harris

Manager - Technical Sales

June 11, 2026

6 min read

Why we spent years building a robot that understands flanges

Flanges are everywhere on a process plant. A single heat exchanger can have hundreds of them, and during a shutdown, every one needs to be properly torqued. Traditionally, that means sending people in.

In some environments, that’s genuinely punishing work. Sites run around 50 degrees Celsius, with steam-heated pipes adding to the ambient heat. Dense dust. Cramped access. Pneumatic tooling that discharges loudly every time it releases pressure.

TMT’s Boltron Flange Bolting Robot exists because those conditions are routine, and the industry deserves a better, safer answer.

Boltron RH OVERALL scaled

The geometry

Every flange has a Pitch Circle Diameter (PCD): the circular pattern the bolts sit on. Once you know the PCD, you can calculate every bolt position mathematically.

"It's really just mathematics. But having a software program that can go around and say, I've looked at that point and that point, therefore I know what the diameter is, the PCD, the bolting pattern. That's where engineering earns its keep."

Boltron identifies three reference points, computes the diameter and bolt pattern from there, then works its way around autonomously. Most flanges follow API sizing, so the bolt count and spacing are predictable once the PCD is confirmed.

The reaction problem

If you put a torque gun on the front of a bolt and apply force, the rear nut spins. You achieve nothing.

"If you just engage on the front and start to tighten it up, the back of it will spin. Ours has a reaction part that actually comes in and closes at the back - it captures the whole fastener, front and back. Without that, the whole mechanism is pointless."

The sequence

Hitting the right torque value is only half of it. Sequence matters for sealing. Going around a flange circumferentially pulls one side down unevenly, creating leak paths.
The correct approach starts at 12, 6, 3 and 9 o’clock, then works through the full pattern before a final sweep. Boltron follows this protocol and measures and records the torque applied to each fastener.

Where it's going

TMT exhibited the Boltron at the Perth Mining Expo with Alcoa as an early partner. The current deployment with a Queensland Partner is moving to an electric torque system, which removes the pneumatic noise and suits the site environment better.

Boltron Arm scaled

Why this matters now

"Any process plant, whether it's on the Northwest Shelf, Woodside's LNG facility, or down on the Kwinana strip - there are so many places with flanges that need to be opened up for maintenance, for shutdowns. We see big potential in this."

Any process plant has flanges. Any plant that does shutdowns has this problem. The market for consistent, automated, measured torque application is large, and TMT is only beginning to explore it.

Check out more about the Boltron Flange Bolting Robot here

Find out how TMT can engineer the solutions & tools you need

Get an Estimate

Name(Required)

Discuss a Project

Name(Required)